Owner's library Kia Seltos Manuals Owner's manual pages, service notes, maintenance references and practical Kia Seltos help in one clean library.

Kia Seltos reference pages

Manuals, maintenance notes and quick owner help.

Find Kia Seltos operating instructions, warning light explanations, service information and owner guidance without digging through a full PDF.

Kia Seltos SP2 (2021-2026) Service Manual / Restraint / General Safety Information and Caution

Kia Seltos: Restraint / General Safety Information and Caution

Precautions when repairing the SRS
When repairing the SRS, pay attention to the following items.
Warning    
If the items below are not observed, there is a possibility of serious injury due to unexpected airbag deployment, and the airbag may not operate.
1.
After disconnecting the battery negative (-) terminal, wait at least 3 minutes and 30 seconds. (Backup power is valid for about 150ms)

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

Safety Precautions for Airbag System Service (Play ▶)Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration
Notes When Refering Video
This video helps recognize potential hazards in advance and ensures procedures are performed correctly when safety precautions are required or when failure to follow steps or procedural errors could affect driving safety.
•
This video is created using common specifications and may differ from the actual vehicle.
•
The location and repair procedures of the parts may vary depending on vehicle model, model year, region, and specifications.
•
Check the KDS Guide for detailed information on how to use the KDS.
•
Check the manual for detailed maintenance procedures.
•
Unauthorized reproduction, distribution, or sharing of this video is prohibited.
2.
Failure symptoms of the airbag system are difficult to identify. When troubleshooting, the DTC provides the most important information.
3.
When repairing an airbag system fault, always inspect the DTC before removing the battery.
4.
Do not measure the resistance of the airbag squib connector. (It is very dangerous because the airbag can be activated.)
Information    
Squib : It is an ignition device installed in the inflator of the electric airbag module.
5.
Be careful not to damage the airbag module by oil, grease, cleaner and water.
6.
Do not use airbag components from other vehicles.
7.
When replacing components, replace them with new ones.
8.
Do not disassemble or repair to reuse for all airbag system components.
9.
When installing the SRS, be careful not to impact around the SRS Control Module (SRSCM) and the collision detection sensor. The airbag may be suddenly deployed, which may cause damage and injury.
10.
If the airbag module is dropped or other defects such as cracks, dents on the case, the bracket and the connector are occurred, replace them with new ones.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

11.
After completing the airbag system repair, check the warning lamp and delete the DTC.
Note    
The operation of the airbag warning lamp may be blocked by other circuit faults. Therefore, when the airbag warning lamp turns on, the DTC is deleted by using the KDS.
12.
After completing the repair and inspection of the SRS, be sure to initialize the system. (Keep IG ON for more than 7 seconds → Keep IG OFF for more than 3 minutes and 30 seconds → Keep IG ON for more than 7 seconds)
Airbag Handling and Storage
1.
Do not disassemble the airbag.
2.
The deployed airbags cannot be reused.
3.
Be sure to observe the following precautions when storing the airbag module.
•
Store the airbag module with the top side of the cover facing upward.
•
The double locking connector lever must be locked, and positioned so that the connector is not damaged.
•
Be careful not to damage the airbag module by oil, grease, cleaner and water.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

•
Store in a place where the ambient temperature is below 60°C (140°F), humidity is not high, and there is no electrical noise.
•
Follow the disposal procedure for the damaged airbag modules.
(Refer to Airbag Module - "The Airbag Module Disposal Procedure")
Wiring Precautions
Observe the precautions described below.
•
Never reconnect or repair the damaged airbag wiring. If the airbag wiring is damaged, replace the harness.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

•
Make sure the wiring is not interfered with other components.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

•
Make sure that there are no foreign substances on the connector surface of the airbag module. Poor grounding can cause problems that are difficult to diagnose.
Precautions for Inspections
When using the tester, insert the tester probe into the connector wire side. Do not insert the tester probe into the terminal side of the connector.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

Use a U-shaped probe and do not forcefully insert the probe.
Airbag Connector Precautions
1.
Disconnect the connector
To disconnect the connector, remove the connector by holding the connector and pulling the spring loaded sleeve (A) and slider (B) from the opposite side. Be careful to pull the sleeve, not the connector.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

2.
Connect the connector
Hold both connectors and push firmly until the protrusion (C) of the connector on the sleeve side clicks into place.

Restraint — General Safety Information and Caution / Precautions when repairing the SRS illustration

Abbreviation
Abbreviation
Name
Driver Airbag (DAB)
Driver Airbag
Passenger Airbag (PAB)
Passenger Airbag
Side Airbag (SAB)
Side Airbag
Curtain Airbag (CAB)
Curtain Airbag
Knee Airbag (KAB)
Knee Airbag
Supplemental Restraint System Control Module (SRSCM)
Supplemental Restraint System Control Module
Front Impact Sensor (FIS)
Front Impact Sensor
P-SIS (Pressure type Side Impact Sensor)
Pressure type Front Side Impact Sensor
A-FSIS (Acceleration type Front Side Impact Sensor)
Acceleration type Front Side Impact Sensor
A-RSIS (Acceleration type Rear Side Impact Sensor)
Acceleration type Rear Side Impact Sensor

Other information:

Kia Seltos SP2 (2021-2026) Service Manual: Windows

The doors of the Kia Seltos are equipped with power windows that can be operated using the window switches. The power window system provides convenient control for the driver and passengers, while the driver can also restrict rear window operation when needed. Driver's door power window switch Front passenger's door power window switch Rear door left power window switch Rear door right power window switch Window opening and closing Automatic power window up*/down* Power window lock switch *: if equipped NOTICE In cold and wet weather, the power windows may not operate properly because of freezing conditions.

Kia Seltos SP2 (2021-2026) Service Manual: Intelligent Speed Limit Assist (ISLA)

Intelligent Speed Limit Assist (ISLA) in the Kia Seltos uses information from detected road signs and, when equipped, the navigation system to inform the driver of the current road speed limit and related information. ISLA helps the driver stay aware of posted limits and maintain a speed appropriate for the road. CAUTION ISLA may not operate properly if the function is used in countries or regions where the system data, road signs, or navigation information are not supported.