Owner's library Kia Seltos Manuals Owner's manual pages, service notes, maintenance references and practical Kia Seltos help in one clean library.

Kia Seltos reference pages

Manuals, maintenance notes and quick owner help.

Find Kia Seltos operating instructions, warning light explanations, service information and owner guidance without digging through a full PDF.

Kia Seltos: Body (Interior and Exterior) / Tailgate Glass

Contents:

Removal and Installation

Removal
1.
Remove the tailgate lid trim.
(Refer to Tailgate - "Tailgate Lid Trim")
2.
Remove the rear spoiler.
(Refer to Body Side Molding - "Rear Spoiler")
3.
Remove the rear wiper motor.
(Refer to Body Electrical System - "Wiper Motor")
4.
Disconnect the tailgate heated wire connector (A).

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Removal illustration

5.
Insert the piano wire (A) in the corner side.

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Removal illustration

6.
Cut the sealant of forward edge side (B) by pulling the piano wire (A) left and right.

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Removal illustration

Caution    
•
Be careful not to burn hands as the excessive heat may be generated while using the wire.
•
Be careful as the wire may break when working.
7.
Cut the sealant in the sections (A-A), (B-B), and (C-C) by pulling the piano wire left and right.

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Removal illustration

Caution    
•
Be careful not to burn hands as the excessive heat may be generated while using the wire.
•
Be careful as the wire may break when working.
8.
Remove the tailgate glass (A) carefully using a glass holder (B).

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Removal illustration

Installation
1.
Clean the edges of the body panel and the tailgate glass with alcohol, etc.
2.
Apply the body primer to the edge of the body panel (A).

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Installation illustration

Note    
•
Be careful not to touch the primed surface with your hands, as water leakage may occur after the tailgate glass is installed.
•
Do not apply the glass primer to the body.
•
Do not smear the primer-covered surface to any foreign materials.
3.
Apply the glass primer to the edge of tailgate glass.

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Installation illustration

Note    
•
Be careful not to touch the primed surface with your hands, as water leakage may occur after the tailgate glass is installed.
•
Do not smear the primer-covered surface to any foreign materials.
4.
Apply the sealant (B) around the tailgate glass (A) using the sealant gun.

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Installation illustration

5.
Using the glass holder, adjust the tailgate glass (A) to stopper hole (B) on the body and carefully tap the tailgate glass to make the edges fully seated on the bonding surface of body.

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Installation illustration

6.
Connect the tailgate heated wire connector (A).

Body (Interior and Exterior) — Tailgate Glass / Removal and Installation / Installation illustration

7.
Perform a water leak test at least 3 to 4 hours later after installing the tailgate glass.
Note    
Keep the water stream away from directly touching the newly installed adhesive surface and let the water fall on the side of the glass.
8.
If a water leak occurs, apply sealant to the water leak area.
Note    
•
Leave the car on a flat surface for at least 4 hours after installing the tailgate glass. If driving the car is inevitable, drive at a low speed in least 8 hours.
•
The driver should be careful to drive the vehicle aggressively or avoid uneven road driving for 2-3 days.
9.
Install the rear wiper motor.
(Refer to Body Electrical System - "Wiper Motor")
10.
Install the rear spoiler.
(Refer to Body Side Molding - "Rear Spoiler")
11.
Install the tailgate lid trim.
(Refer to Tailgate - "Tailgate Lid Trim")

Other information:

Kia Seltos SP2 (2021-2026) Service Manual: Driver Attention Warning (DAW)

Inattentive Driving Warning function Driver Attention Warning (DAW) in the Kia Seltos monitors driving patterns while the vehicle is being driven. If the system determines that the driver's attention level has dropped below a certain point, DAW may recommend taking a break to help support safer driving. Leading Vehicle Departure Alert function Leading Vehicle Departure Alert informs the driver when the detected vehicle in front begins moving away from a stop.

Kia Seltos SP2 (2021-2026) Service Manual: Selecting a CRS

When selecting a Child Restraint System for your child, always choose a restraint that fits the child, fits the Kia Seltos seating position, and can be installed according to the manufacturer's instructions. Make sure the CRS has a label certifying that it meets FMVSS 213. Select a child restraint based on your child's height and weight.