Owner's library Kia Seltos Manuals Owner's manual pages, service notes, maintenance references and practical Kia Seltos help in one clean library.

Kia Seltos reference pages

Manuals, maintenance notes and quick owner help.

Find Kia Seltos operating instructions, warning light explanations, service information and owner guidance without digging through a full PDF.

Kia Seltos: Charging System / Troubleshooting

Troubleshooting
Note    
•
Be careful not to short-circuit the wiring by the vehicle body or other wiring.
•
In case of discharging problem, measure parasitic current at all times.
(Refer to Charging System - "Battery")
•
When checking the alternator main fuse, perform continuity test and voltage test between terminals as well as visual check to confirm normal operation.
•
When checking the ground, repair or replace after inspecting for defective ground cable, defective installation or defective contact due to foreign object.
•
It is not recommended to use non-authentic parts as installing non-authentic parts may cause malfunction of charging system.
•
Be careful as misassembly may cause short-circuit of wiring, which may result in battery discharge.
•
When measuring parasitic current, if the battery ( - ) terminal is disconnected, it may be displayed as normal due to initialization, so measure using a clamp type ammeter without removing the ( - ) terminal.
•
Note that there may be various phenomena / possible causes / repair measures apart from above.
•
For more effective repairs, refer to DTC guide and ETM.
Charging warning lamp does not turn on during IG ON
Suspected causes
Correction
Broken alternator main fuse
Replace alternator main fuse
Broken instrument cluster fuse
Replace instrument cluster fuse
Defective connection of wiring connector
Inspect wiring connection
Defective regulator or alternator
Replace regulator or alternator
Defective connection of battery terminal
Inspect tightening of positive ( + ) and negative ( - ) battery terminals to specified torque
Communication error
Inspect wiring between regulator and Engine Control Module (ECM).
Inspect transmit signal of ECM
Inspect or replace alternator if wiring and ECM are normal

Charging warning lamp does not turn off during engine running
Suspected causes
Correction
Worn drive belt or lack of tension
Adjust the tension or replace of the drive belt
Defective connection, corroded or worn battery cable
Inspect connection of battery cable and repair or replace cable
Broken alternator main fuse
Replace alternator main fuse
Defective regulator or alternator
Replace regulator or alternator
Ignition wiring fault
Repair or replace the wiring
Defective instrument cluster
Inspect the instrument cluster and replace it if necessary
Slip in alternator pulley
Inspect or replace alternator pulley
Adjust the tension or replace of the drive belt
Defective connection of battery terminal
Inspect tightening of positive ( + ) and negative ( - ) battery terminals to specified torque

Charging warning lamp turns on
Suspected causes
Correction
Slip, worn or lack of tension in drive belt
Adjust the tension or replace of the drive belt
Replace auto tensioner (only for auto tensioner type)
Error in Alternator Management System (AMS) voltage
Connect the battery sensor and check for short circuits with the harness and body of the vehicle
Error in battery sensor
Inspect or replace battery sensor
Short between battery sensor wiring and body
Replace battery sensor
Warning light illuminating due to output power of the L terminal of the alternator
Replace alternator or regulator
Deterioration occurs due to poor positive ( + ) terminal contact
Inspect tightening of positive ( + ) battery terminal to specified torque
Internal pin of alternator that is connected with extension connector shorted
Repair the pin or inspect/replace the wiring
Short between the body and transaxle ground cable
Connect or repair ground cable
Communication error
Inspect wiring between regulator and ECM
Inspect transmit signal of ECM
Inspect or replace alternator if wiring and ECM are normal
A short circuit occurred in the harness connected to the alternator L terminal
Repair or replace wiring after inspection
Drive belt rotation stops due to slip in crankshaft damper pulley or defective pulley
Inspection/replace the crankshaft damper pulley or drive belt tensioner bearing
Defective regulator
Replace regulator
Defective alternator
Replace alternator
Broken alternator main fuse
Replace alternator main fuse
Defective ground
Inspect or repair ground

Discharged battery
Suspected causes
Correction
Worn drive belt or lack of tension
Adjust the tension or replace of the drive belt
Bad wiring connection and short circuit
Inspect connection of wiring and repair or replace wiring
Broken alternator main fuse
Replace alternator main fuse
Defective regulator or alternator
Replace regulator or alternator
Defective ground
Inspect or repair ground
Damaged and defective battery
Replace battery
Parasitic current exceeding the specified value
Repair or replace after measuring the parasitic current
Assembly fault and defective parts due to modification of electrical device
Repair the vehicle by using the genuine parts
Low state of charge
Learn or replace battery sensor
Battery wiring damaged or broken
Repair or replace wiring after inspection
Parasitic battery drain due to defective ECM main control relay
Inspect or replace ECM
Defective wiring harness due to moisture
Repair or replace wiring
Defective body electronic parts
Replace the body electronic parts
Parasitic battery drain due to defective ECM
Inspect or replace ECM
Defective connection of alternator connector
Connect the connector correctly

Swollen battery
Suspected causes
Correction
Defective battery
Inspect or replace battery
Defective regulator or alternator
Repair or replace after inspecting the regulator and alternator
Defective parts and wiring related to charging
Repair or replace the parts related to charging and wiring after inspection

The battery does not charge properly during idling (normally charging during the acceleration)
Suspected causes
Correction
Bad wiring connection and circuit
Inspect connection of wiring and repair or replace wiring
Defective connector pins connection
Inspect connection of wiring and repair or replace wiring

Alternator main fuse blown frequently
Suspected causes
Correction
Short or open in battery wiring
Check wiring connections and repair or replace wiring (If the battery wiring is normal, check the rest of the wiring)

The charging warning light and other warning lights illuminate at the same time
Suspected causes
Correction
short circuit occurred between the other warning lights and the alternator L terminal. ( L terminal type of the alternator applied vehicle only)
Repair or replace wiring after inspection

Engine warning lamp on
Suspected causes
Correction
Battery sensor bolt loosening
Tighten to specified torque

Dimming headlights
Suspected causes
Correction
Defective wiring and wiring connection
Inspect connection of wiring and repair or replace wiring

Other information:

Kia Seltos SP2 (2021-2026) Service Manual: Air bag - advanced Supplemental Restraint System

* The actual air bags and their locations in your Kia Seltos may differ from the illustration depending on model, trim, and equipment. Driver's front air bag Passenger's front air bag Side air bag Curtain air bag Even in vehicles equipped with air bags, the driver and all passengers must always wear the safety belts provided.

Kia Seltos SP2 (2021-2026) Service Manual: LCD display

The Kia Seltos LCD display modes can be changed using the control buttons on the steering wheel. These modes provide access to driving information, vehicle settings, warning messages, and system status screens. LCD Display Control : MODE button for changing display modes / : MOVE switch for changing items OK: SELECT/RESET button for selecting, confirming, or resetting the highlighted item