Kia Seltos: Front Suspension System / Front Sub Frame Removal and Installation
| Special Service Tool |
|
Tool Name / Number |
Illustration |
Description |
|
Ball joint puller 09568 - 1S100 |
|
Used for removal of tie rod end |
|
Ball joint puller 0K545 - A9100 |
|
Used for removal of front lower arm ball joint |
| Removal |
| 1. |
Align the steering wheel in a straight-ahead position using a digital level or other equivalent tools.
|
| 2. |
Fix the steering wheel by using a tool such as a steering wheel holder.
|
| 3. |
Remove the bolt, and then separate the universal joint (A) from the steering gear box.
|
| 4. |
Remove the front wheel and tires.
(Refer to Tires/Wheels - "Wheel")
|
| 5. |
Separate the stabilizer bar link from the front strut assembly after removing the nut (A).
|
| 6. |
Separate the lower arm ball joint from the front axle.
|
| 7. |
Separate the tie rod end ball joint from the front axle.
|
| 8. |
Remove the engine room rear under cover (A) after removing the nuts.
|
| 9. |
Remove the engine room under cover.
G 1.6 T-GDI GAMMA II (Refer to Engine Mechanical System - "Engine Room
Under Cover")
G 2.0 MPI NU (Refer to Engine Mechanical System - "Engine Room Under
Cover")
|
| 10. |
Remove the bolt (A), and then separate the roll rod bracket from the roll rod support bracket.
|
| 11. |
Remove the muffler rubber hanger (A) from the front sub frame.
|
| 12. |
Remove the front sub frame stay (A).
[LH]
[RH]
|
| 13. |
Support the front sub frame (A) with the jack (B) such as the transmission jack, and remove the front sub
frame after removing the nut.
|
| 14. |
Remove the roll rod bracket (A) after removing the bolts.
|
| 15. |
Remove the front stabilizer bar (A) after removing the bolts.
|
| 16. |
Remove the steering gear box heat protector (A) after removing the bolts.
|
| 17. |
Remove the steering gear box (A) after removing the bolts.
|
| 18. |
Remove the front lower arm (A) after removing the bolts and nuts.
|
| Installation |
| 1. |
Install in reverse order of removal.
|
| 2. |
Check the alignment.
(Refer to Alignment - "Repair Procedures")
|
Other information:
Kia Seltos SP2 (2021-2026) Service Manual: LCD display modes
You can switch between LCD display modes by pressing the Mode button. The available screens may differ depending on the Kia Seltos trim level, equipment, and active vehicle systems. Mode Driving Assist Trip Computer TuKia Seltos SP2 (2021-2026) Service Manual: Idle Stop and Go (ISG) system
The Idle Stop and Go (ISG) system in the Kia Seltos helps reduce fuel consumption by automatically turning off the engine when the vehicle is stopped, such as at a red light, stop sign, or in heavy traffic. The engine restarts automatically as soon as the required starting conditions are met, allowing the driver to continue smoothly without using the ignition switch or ENGINE START/STOP button manually.

