Kia Seltos: Body (Interior and Exterior) / Hood
Contents:
- Components and Components Location
- Adjustment
- Hood Assembly Removal and Installation
- Hood Insulator Pad Removal and Installation
- Hood Latch Release Handle Removal and Installation
- Hood Latch Assembly Removal and Installation
Components and Components Location
| Component |

| 1. Hood Assembly 1-a. 18.6 - 27.5 N·m (1.9 - 2.8 kgf·m, 13.7 - 20.3 lb·ft) 2. Hood Insulator Pad 3. Hood Hinge 3-a. 21.6 - 26.5 N·m (2.2 - 2.7 kgf·m, 15.9 - 19.5 lb·ft) 4. Hood Lifter |
5. Hood Latch Assembly 5-a. 6.9 - 10.8 N·m (0.7 - 1.1 kgf·m, 5.1 - 8 lb·ft) 6. Hood Latch Release Handle 7. Hood Latch Release Cable |
Adjustment
| Adjustment |
| 1. |
Loosen the hood hinge (A) bolt to the body.
|
| 2. |
Tighten the bolt after adjusting the hood by moving it in all directions.
|
| 3. |
Adjust the height of the hood by turning the overslam bumper (B) in clockwise and counterclockwise.
|
| 4. |
Loosen the hood latch (C) bolts, adjust the hood latch by moving it up, down, left and right, and then
tighten the bolts.
|
| 5. |
When the hood is closed after the completion of adjustment, check if there is an iron noise when the
front hood latch area of the hood assembly outer plate is tapped. If there is iron noise, increase the
overlap by adjusting the two hood over slam bumpers down one quarter to a half of a turn.
|
Hood Assembly Removal and Installation
| Removal |
Work with at least 2 people when removing the part.
|
| 1. |
Remove the hood assembly (A) after removing the bolts.
|
| Installation |
| 1. |
Install in reverse order of removal.
|
Hood Insulator Pad Removal and Installation
| Removal |
| 1. |
Remove the hood insulator pad (A) after removing the clips.
|
| Installation |
| 1. |
Install in reverse order of removal.
|
Hood Latch Release Handle Removal and Installation
| Removal |
| 1. |
Remove the hood latch release handle (A) after retracting the fixing hook inside.
|
| Installation |
| 1. |
Install in reverse order of removal.
|
Hood Latch Assembly Removal and Installation
| Removal |
| 1. |
Disconnect the battery negative ( - ) terminal.
|
| 2. |
Disconnect the hood latch connector (A).
|
| 3. |
Remove the hood latch wiring clips (A).
|
| 4. |
Remove the hood latch assembly (A) after removing the bolts.
|
| 5. |
Separate the cable (A).
|
| Installation |
| 1. |
Install in reverse order of removal.
|

