Kia Seltos SP2 (2021-2026) Service Manual / All Wheel Drive (AWD) System / Specification
Kia Seltos: All Wheel Drive (AWD) System / Specification
Contents:
Tightening torque
| Tightening Torque |
Tranfer assembly
| Transfer Oil |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Transfer oil drain plug |
39.2 - 58.8 |
4.0 - 6.0 |
28.9 - 43.4 |
|
Transfer oil filler plug |
39.2 - 58.8 |
4.0 - 6.0 |
28.9 - 43.4 |
| Tranfer Assembly |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Front sub frame rear under cover and front sub frame nut |
7.8 - 11.8 |
0.8 - 1.2 |
5.8 - 8.7 |
|
Propeller shaft bolt |
49.0 - 68.6 |
5.0 - 7.0 |
36.2 - 50.6 |
|
Transfer assembly bolt |
60.8 - 65.7 |
6.2 - 6.7 |
44.8 - 48.5 |
AWD Control System
| AWD ECU |
|
Item |
N·m |
kgf·m |
lb·ft |
|
AWD ECU nut |
9.8 - 11.8 |
1.0 - 1.2 |
7.2 - 8.7 |
Coupling Assembly
| Direct Electro Hydraulic Actuator Coupling |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Propeller shaft bolt |
49.0 - 68.6 |
5.0 - 7.0 |
36.2 - 50.6 |
|
Direct electro hydraulic actuator coupling assembly bolt |
56.9 - 64.7 |
5.8 - 6.6 |
42.0 - 47.7 |
| Hydraulic Motor (Actuator) |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Hydraulic motor bolt |
9.8 - 11.8 |
1.0 - 1.2 |
7.2 - 8.7 |
| Pressure Sensor |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Pressure sensor |
10.8 - 14.7 |
1.1 - 1.5 |
8.0 - 10.8 |
Rear Driveshaft Assembly
| Rear Driveshaft |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Rear wheel speed sensor bolt |
8.8 - 13.7 |
0.9 - 1.4 |
6.5 - 10.1 |
|
Rear driveshaft lock nut |
274.6 - 294.2 |
28.0 - 30.0 |
202.5 - 217.0 |
|
Rear upper arm and rear carrier bolt and nut |
137.3 - 156.9 |
14.0 - 16.0 |
101.3 - 115.7 |
|
Rear lower arm and rear carrier bolt and nut |
137.3 - 156.9 |
14.0 - 16.0 |
101.3 - 115.7 |
|
Rear trailing arm and rear carrier bolt |
137.3 - 156.9 |
14.0 - 16.0 |
101.3 - 115.7 |
|
Rear assist arm and rear carrier bolt and nut |
137.3 - 156.9 |
14.0 - 16.0 |
101.3 - 115.7 |
Propeller Shaft Assembly
| Propeller Shaft |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Front sub frame rear under cover and front sub frame nut |
9.8 - 11.8 |
1.0 - 1.2 |
7.2 - 8.7 |
|
Front propeller shaft and front transfer assembly bolt |
49.0 - 68.6 |
5.0 - 7.0 |
36.2 - 50.6 |
|
Rear tube and coupling assembly bolt |
49.0 - 68.6 |
5.0 - 7.0 |
36.2 - 50.6 |
|
Center bearing bracket and body bolt |
49.0 - 68.6 |
5.0 - 7.0 |
36.2 - 50.6 |
Rear Differential Carrier Assembly
| Rear Differential Carrier |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Rear differential carrier assembly and rear cross member bolt |
68.6 - 88.3 |
7.0 - 9.0 |
50.6 - 65.1 |
|
Rear differential carrier assembly and bracket bolt |
56.9 - 64.7 |
5.8 - 6.6 |
42.0 - 47.7 |
|
Rear differential carrier assembly and air bleeder |
9.8 - 19.6 |
1.0 - 2.0 |
7.2 - 14.5 |
|
Differential carrier case side cover bolt |
39.2 - 49.0 |
4.0 - 5.0 |
28.9 - 36.2 |
|
Gear carrier and ring gear bolt |
78.5 - 88.3 |
8.0 - 9.0 |
57.9 - 65.1 |
|
Differential carrier filler plug |
39.2 - 58.8 |
4.0 - 6.0 |
28.9 - 43.4 |
| Rear Differential Carrier Gear Oil |
|
Item |
N·m |
kgf·m |
lb·ft |
|
Rear differential carrier drain plug |
49.0 - 68.6 |
5.0 - 7.0 |
36.2 - 50.6 |
|
Rear differential carrier filler plug |
39.2 - 58.8 |
4.0 - 6.0 |
28.9 - 43.4 |
Lubricant
| Lubricant |
| Fluid |
|
Item |
Capacity |
| Transfer oil |
About 0.50 â„“ (0.13 U.S.gal., 0.52 U.S.qt, 0.43 Imp.qt.) |
| Rear differential carrier oil |
About 0.58 â„“ (0.15 U.S.gal., 0.61 U.S.qt, 0.51 Imp.qt.) |
| Grease |
|
Item |
Recommended grease |
Capacity |
|
Transfer spline |
TECHRUBE MEGAMAX-ALPHA, CASMOLY CSG 101 M or equivalent |
2.0 - 5.0 g |
|
Coupling spline |
2.0 - 6.0 g |
Other information:
Kia Seltos SP2 (2021-2026) Service Manual: Closing the fuel filler door
To install the fuel cap on the Kia Seltos, turn it clockwise until it clicks one time. This click indicates that the cap is securely tightened and properly sealed. Close the fuel filler door and press it lightly to make sure it is fully closed and flush with the body of the vehicle. WARNING Refueling Always remove the fuel cap carefully and slowly.Kia Seltos SP2 (2021-2026) Service Manual: Automatic transmission
Depress the brake pedal and press the lock release button when shifting. Press the lock release button when shifting. The shift lever can be moved freely.