Kia Seltos SP2 (2021-2026) Service Manual / All Wheel Drive (AWD) System / Rear Driveshaft Assembly
Kia Seltos: All Wheel Drive (AWD) System / Rear Driveshaft Assembly
Contents:
Rear Driveshaft Components and Components Location
| Component |
| 1. Rear Driveshaft (LH) |
2. Rear Driveshaft (RH) |
Rear Driveshaft Removal and Installation
| Special Service Tool |
|
Tool Name / Number |
Illustration |
Description |
|
CV joint puller 09517 - 4E000 |
|
Used for removal of CV joint |
| Removal |
| 1. |
Disconnect the battery negative (-) terminal.
|
| 2. |
Remove the rear wheel and tires.
(Refer to Suspension System - "Wheel")
|
| 3. |
Remove the rear wheel speed sensor clip (A).
|
| 4. |
Remove the rear wheel speed sensor (A) after removing the bolt.
|
| 5. |
Unlock the rear driveshaft lock nut caulking (A), by hammering on a chisel or suitable tool.
|
| 6. |
Remove the rear driveshaft lock nut (A).
|
| 7. |
Separate the rear driveshaft from the rear axle assembly using the SST (09517 - 4E000).
|
| 8. |
Remove the rear brake disc.
(Refer to Brake System - "Rear Brake Disc")
|
| 9. |
Separate the rear upper arm (A) after removing the bolt and nut.
|
| 10. |
Remove the rear lower arm mounting nut and bolt (A).
|
| 11. |
Remove the rear trailing arm mounting bolts (A) and washers (B).
|
| 12. |
Remove the rear axle assembly (A) after removing the rear assist arm bolt, washer and nut.
|
| 13. |
Remove the rear driveshaft (A).
|
| Installation |
| 1. |
Install in reverse order of removal.
|
| 2. |
Check the alignment.
(Refer to Suspension System - "Alignment")
|

