Owner's library Kia Seltos Manuals Owner's manual pages, service notes, maintenance references and practical Kia Seltos help in one clean library.

Kia Seltos reference pages

Manuals, maintenance notes and quick owner help.

Find Kia Seltos operating instructions, warning light explanations, service information and owner guidance without digging through a full PDF.

Kia Seltos: Driveshaft and Axle

Contents:

Single-Use Parts

Single-Use Parts
Non-reusable parts (Single-Use Parts)
Workshop manual provides “Components and Components Location� which can be used to identify “Non-reusable parts�. When repairing a vehicle, Non-reusable parts such as fasteners, gaskets, washers, clips and garnishes must be replaced. Kia Non-reusable parts are designed to be installed only once.
Before working on a vehicle, check “Components and Components Location� to find the non-reusable parts in a system.
※ Symbol of Non-reusable parts
Symbol
Meaning

Driveshaft and Axle — Single-Use Parts illustration

Do not reuse the part. Replace with a new one.

※ Example of “Components and Components Location�

Driveshaft and Axle — Single-Use Parts illustration

Specification ➤

Special Service Tools

Special Service Tool
Tool Name / Number
Illustration
Description
Lower arm ball joint remover
0K545 - A9100

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of front lower arm ball joint
Ball joint puller
09568 - 1S100

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of tie rod end
CV joint puller
09517 - 4E000

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of CV joint
Band installer
0K495 - 2W000

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for installing hook type boot band (low profile) (Sharing handle with 0K495 - C5000)
Band installer
0K495 - C5000

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for installing ear type boot band (Sharing handle with 0K495 - 2W000)
Sliding hammer
09526 - 11100

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of CV joint
(Used with 0K495 - C5200)
Adaptor
0K495 - C5200

Driveshaft and Axle — Special Service Tools / Special Service Tool illustration

Used for removal of CV joint
(Used with 09526 - 11100)

Troubleshooting

Troubleshooting
Symptom
Suspected causes
Repair
Vehicle pulls to one side
Front suspension fault or defect
Wheel alignment adjust or replace
Steering system fault or defect
Note    
Before inspecting or replacing the MDPS, perform the wheel alignment and the steering angle sensor zero-point calibration first.
Wheel alignment adjustment or steering angle sensor zero-point calibration, MDPS inspection or replace
Poor installation of the brake disc and brake pad
Replace
Seized wheel bearing
Replace
Incorrect tire air pressure
Adjustment
Unbalanced wear of tires
Adjust the wheel alignment or replace the tire
Incorrect wheel balance
Adjust or replace
Abnormal wheel alignment
Adjustment
Vibration
Over abrasion, separation, damaged or bended on driveshaft
Replace
(Replacement using repair kit)
Wheel bearing excessive play
Replace
Shimmy
Incorrect wheel balance
Adjust or replace
Defect on front suspension and steering gear
Adjust or replace
Noise
Excessive wear, damaged, or bent driveshaft
Replace
(Replacement using repair kit)
Noise on connecting part of driveshaft and hub while driving straight, back or curve (Clicking or Creaking noise)
Tighten hub nuts
or inner washer replacement
Noise from inner side of shaft while driving curve (Repeated tapping noise)
Replace
(Replacement using repair kit)
Friction noise on driveshaft boots (Sticky noise)
Clean and apply fluorine lubricant
Loose hub nut
Tighten or replace
Defect on front suspension and steering gear
Adjust or replace
Loose disc screw
Adjustment
Noise on wheel bearing while driving (Whir noise)
Replace
Wheel bearing has excessive play, contacted surface of flange burnt
Replace
Leakage
Leakage of grease on driveshaft boots (partial parts replacement when inboard side boots has leakage)
Replace
(Replacement using repair kit)
Rust
Corrosion on nonpainting area (Not a problem for functioning)
Explain to the customer it is normal
ABS warning lamp illuminated
Loose wheel bearing sensor and sensor cable
Adjustment
Contaminated wheel bearing sensor connector
Cleaning
Communication error (Diagnosis using KDS)
Adjustment

Front Axle Assembly ➤

Rear Axle Assembly ➤

Driveshaft Assembly ➤

Other information:

Kia Seltos SP2 (2021-2026) Service Manual: Remote keyless entry

The remote keyless entry system allows you to lock and unlock the Kia Seltos doors from a distance for convenience and security. Remote keyless entry system operations Folding key Smart key - Type A Smart key - Type B Lock (1) All doors are locked when the lock button is pressed. If all doors are closed, the hazard warning lights will blink, and the chime will sound once for the smart key to confirm that all doors are locked.

Kia Seltos SP2 (2021-2026) Service Manual: Limitations of NSCC

Navigation-based Smart Cruise Control (NSCC) in the Kia Seltos may not operate properly under certain road, navigation, weather, or system conditions. The driver must always monitor the road and remain ready to control speed manually. The navigation system is not operating properly. Map information is not transmitted because of abnormal infotainment system operation.